Cornick Help Center

    SPKR-TAV Recorder Settings and Wiring.

    Configuring Alarm Output for Motion Detection on a compatible Recorder to work with the SPKR-TAV

    In this example, we will be wiring a SPKR-TAV to a recorder. When a camera triggers motion detection, the SPKR-TAV will trigger.

    This is the wiring diagram for the SPKR-TAV. As you can see, the cable will have four coloured wires.

    The Black & White cables needs to be connected to a power supply.
    The Green and Blue wires go to the Alarm Output on the back of the Recorder.
    The Blue wire goes to NO (Normally Open)
    The Green Wire goes to C / COM (Common)
    Make sure the number at the end is the same.
    (e.g Blue wire into NO1 & Green into C1)


    (Black GUI) Recorder Setup

    Navigate to Main Menu > Alarm > Video Detection > Motion Detect


    For each camera you wish to enable an Alarm Output for Motion Detection, do the following:

    1. Select the Camera Channel
    2. Tick Enable
    3. Click Setting next to Alarm Out, then select the Alarm Out channel number. This needs to match the number the Green & Blue wires are connected to. (e.g Alarm Out Channel 1 will activate NO1 & C1)
    4. Select Apply

    (Blue GUI) Recorder Setup

    Navigate to Main Menu > Event > Video Detection > Motion Detect

    For each camera you wish to enable an Alarm Output for Motion Detection, do the following:

    1. Select the Camera Channel
    2. Tick Enable
    3. Tick Alarm Out
    4. Enable Alarm out and select the Alarm Out channel number. This needs to match the number the Green & Blue wires are connected to. (e.g Alarm Out Channel 1 will activate NO1 & C1)
    5. Select Apply

    Was this article helpful?

    Send feedback

    Can’t find what you’re looking for?

    Our customer care team is here for you.

    Contact Support