Support Home Building Alarms ALM-D1 ALM-D1-RSW Hardwired access as External detector

ALM-D1-RSW Hardwired access as External detector

Step-by-Step Guide to Configure a Wireless Reed Door as an External Detector

Connect the Wired Peripheral: Use a cable to connect the wired peripheral to the rolling door controller.

Access the ALM-D1 Page: Open the ALM-D1 page on your device.

Navigate to Devices: Tap on [Devices] located at the bottom left corner of the screen on your phone.

Select the Reed Detector: Choose the reed door sensor with hardwired access as the external detector, then tap on [Device Details]

Go to Settings: Tap on [Settings].

Scroll to External Input: Scroll down the page until you find [External Input], then tap to enter this section.

Enable External Input: Switch the [External Input] toggle to the "ON" position to enable this function.

Configuration input:

External Detector Type: will be set [Sensor] (default) for detecting when the rolling door is opened.
Area: assign to the specific area where it is connected (rolling door area).
External Detector Type: will be set [Normally Open] (default). The alarm will trigger when the rolling door is opened .
Shared Peripheral Alarm: will be set [Shared Config] (default)

Can’t find what you’re looking for?

Our customer care team is here for you.

Contact Support