Product Overview
LED Indication
Green LED is steady on: working mode.
Blue LED flashes once: signal transmitting
Green and blue LEDs flash alternately: in connect mode
Adding and Deleting Accessories
When adding or deleting accessories, you should make this ALC-RPT1 in learning or deleting accessories mode:
- Turn the ALC-RPT1 switch from OFF to ON (If it is ON mode, turn it to OFF first)
- The ALC-RPT1 will beep once to enter learning or deleting accessories mode for one minute while the green and blue light flash alternately.
Extend Transmission Distance Between Accessories and Control Panel
When the ALC-RPT1 is in connect mode (the green and blue lights flash alternately):
- Press connect button, will hear one short beep
- Trigger a wireless detector. The blue LED should light up for 2 seconds following a long beep.
- If the repeater is still in connect status; you can repeat the above operation to add more accessories.
- ALC-RPT1 will be on working mode after 60 seconds powered up
Note: If the ALC-RPT1 exits the connect mode, switch off and then switch on the ALC-RPT1 to re-enter the connect mode. Then repeat the above operation to add more accessories.
Extend Transmission Distance Between Control Panel and Siren
When the ALC-RPT1 is in connect mode (the green and blue lights flash alternatively):
- Press connect button, will hear one short beep
- Press the SOS button on the control panel. The blue LED should light up for 2 seconds following a long beep.
- Then the green and blue LEDs flash alternately.
Reset the ALC-RP1 to factory default
- Turn the switch from OFF to ON, ALC-RPT1 will beep once.
- Press and hold the connect button for 5 seconds under connect mode.
- The blue LED lights up for 2 seconds following 3 beeps and goes off.
- Then the green LED keeps steady on (working mode).
Specifications
Power Supply: AC 110V-240V, 50/60Hz
Wireless Transmitting Range: ≤ 300m
Wireless Receiving Range: ≤90m
Radio Frequency: 315MHz or 433MHz (± 75KHz)
Static Current: ≤ 15.5mA
Transmitting Current: ≤ 1.1A
Maximum Accessories Supportable: 40 PCS
Back-up Battery: 3.7V 600mAh Lithium Battery, 2.22Wh
Housing Material: ABS plastic
Operation Condition:
Temperature: -l0° C ~ +55° C
Relative Humidity: ≤80% (non-condensing)
Dimension (L x W x H): 140 x 86 x 87mm