Cornick Help Center

    WGAP864IPMW Setup

    June 24th, 2022

    Step 1 - Connecting to the Panel

    1. Connect the WGAP864IPMW 12V input to the TX port of the WGAP864 Panel. 
    2. Connect the provided serial cable from the serial connector on the WGAP864 Panel to the serial connector on the WGAP864IPMW. Ensure that the red cable is at the top of the panel (see below images).

    Delete

    Step 2a - (Hardwired) Connect the WGAP864IPMW to the Network

    1. Plug in the Ethernet cable from your network to the Ethernet connector on the WGAP864IPMW.

    2. Disconnect the Wi-Fi module.

    Delete

    Step 2b - (Wi-Fi) Connect the WGAP864IPMW to the Network

    To connect your WGAP864IPMW to Wi-Fi you must have a WPS enabled router.
    To use WPS simply power the WGAP864IPM and when the Panel Comms, Network Comms and Server Auth LEDs start flashing in a clockwise sequence press the WPS button on your router.

    Delete

    Step 3 - Add the WGAP864IPMW to the HYYP App

    1. To install the HYYP App go to the Google Play Store/App Store and search for HYYP, then click Install.

    2. Open the HYYP app and click Sign up here.
    3. Fill in your details, accept the terms and conditions and click Sign Up.
    4. Once registered you will be given a WGAP864IPMW  and asked if you have a WGAP864IPMW to connect. Click I have a new HYYP Hub.
    5. Give your WGAP864IPMW a name and choose a site colour, then click Continue.
    6. Enter the IMEI number or scan the unique barcode on the WGAP864IPMW, then click Continue.

    7. When the app says Sync Device, follow the below steps on the WGAP864 Panels keypad:
    • Enter Installer Code [1][4][7][9][*]
    • Go to location 196 [1][9][6][*]
    • Enter any six digit code [1][2][3][4][5][6][*] (This is to authorize the HYYP serial connection)
    Delete

    Additional Steps if using Back to Base Monitoring

    • Go to location 61 [6][1][*] (This is the partition’s account code: 61 – Partition 1; 62 – Partition 2; 63 – Partition 3…)
    • Enter the account code issued by the control room [1][2][3][4][*]
    • Exit installer programming [#]

    8. Fill in the details of where the alarm system is installed, then click Next.

    9. Your WGAP864IPMW has been successfully synced with the HYYP app.


    Delete

    Was this article helpful?

    Send feedback

    Can’t find what you’re looking for?

    Our customer care team is here for you.

    Contact Support