System – Trouble Display Options
LOCATION 0 is Defaulting the Panel, Master User code or Missing devices…
This location allows you to default to the panel, user codes and their properties, and bus-wired peripherals. Refer to Table 4 for the values that can be programmed, and their actions.
[#] [1479] [*] = Installer Menu
[0] [*] = Default Panel - Action
[VALUE] = select specific data code as the table below to default
[*] = to confirm and updating the settings.
[#] [Installer code] [*] [0] [*] [Value] [*]
Table 4: Defaulting Data
Value |
Action |
0 |
Will reset all locations and ID’s to the factory default values. (Master User Code 1234) |
1 |
Will default the Primary Master User Code back to 1234 - or 123456 if 6 digits are being used. Master User Code properties will also be defaulted. |
2 |
Defaults ALL user codes and their properties. |
3 |
Defaults ALL keypads. |
4 |
Remove Missing Devices. Any missing devices (keypads, for example), will have its address freed up, making its address available for a new device when it is enrolled. This MUST be performed when replacing a faulty device. (You must wait for 30 seconds from device failure or removal.) |
5 |
Default “Central Monitoring Mode”. Defaults DTMF numbers, dialling options, reporting options, reporting code options and sets some options not to factory settings. (Implemented in vers.2) |
6 |
Default “Private Reporting mode”. (Sets some options not to factory settings) (Implemented in v2) |
7 |
Defaults all wireless zones and settings |